PowerSafe SBS蓄电池SBS B14抗腐耐用
Charging •Refreshing Charge: Product in storage (ambient temperature 25ºCrequires a refresh every six months. Apply constant voltage at 2.40Vpc, initial charging current should be set at less than 0.1CA for15 to 20 hours. Discharge • Stop operation when voltage has reachedthe minimum permissible voltage (1.6 Vpc). Recharge immediately. •Do not operate at 3CA or more current continuously. Storage •Always store battery in a fully charged condition. • If battery isto be stored for a long period, apply a recovery refresh chargeevery 6 months. • Store batteries in a dry and coollocation.
充电
·刷新收费:产品在储存中(环境温度25℃,每六个月需要刷新一次)。在2.40VPC处施加恒定电压,初始充电电流应小于0.1CA作用15~20小时。当电压达到Zui小允许电压(1.6VPC)时,放电
·停止工作。立即充电。
·不要连续工作在3CA或以上电流。圣总要在充满电量的情况下储存电池。
·如果电池要储存很长时间,每6个月使用一次恢复刷新充电。
·将电池储存在干燥和凉爽的地方。
Temperature •Keep within ambient temperatures of -15°C to 50°C for both chargingand discharging. Incorporating battery into e • Encasebattery in a well ventilated compartment. • Avoid installingbattery near heated units such as a transformer. • House thebattery in the lowest section of the e enclosure or rack toprevent unnecessary battery temperature rise. Others • Avoidterminal short circuit. • DO NOT expose to open flame. • Avoidsetting batteries in environments which can cause direct contact topetrol, paint thinner, organic solvents, synthetic resins, oil,etc
温度保持在-15°C至50°C的环境温度下,用于BOTH装料和卸料g.将电池装入设备在通风良好的隔间内输入EnCase电池ENT。在受热装置(如变压器)附近安装电池。
·将电池安装在设备外壳或机架的Zui底层,以防止不必要的电池温升。其他
·避免端子短路。
•请勿暴露于明火中。
•避免在可能直接接触汽油、油漆稀释剂、有机溶剂、合成树脂的环境中放置电池,油等
现在的后备式UPS多数配置的是铅酸免维护电池。影响电池使用寿命的因素有:UPS的使用环境、环境温度、充放电电流、充电电压、放电深度,在这些方面需要注意的是:
UPS的使用环境
UPS应尽可能安装在清洁、阴凉、通风、干燥的地方,这样可以减少有害灰尘对UPS内部线路的腐蚀;还要避免受到阳光、加热器(如冬天用的取暖器)或其他辐射热源的影响。UPS应正立放置,不可倾斜角度。
环境温度
环境温度对UPS电池的影响较大,环境温度过高,会使电池过充电产生气体,环境温度过低,则会使电池充电不足,这都会响电池的使用寿命。环境温度在25℃左右是比较理想的,这样的环境温度对电脑主机和显示器也是非常适宜的。
充放电电流
UPS电池充放电电流一般以C来表示,C的实际值与电池容量有关。举例来讲,如果是100AH的电池,则C=100A。充电电流过大或过小都会影响电池的使用寿命。放电电流一般要求在0.05~3C,UPS在正常使用中都能满足此要求,但也要防止意外情况的发生,如电池短路。