GSYUASA蓄电池SNS-3000 2V3000AH应急照明

GSYUASA蓄电池SNS-3000 2V3000AH应急照明

【GSPORTALAC BATTERY】 【日本電池株式會社】 【日本GS电池】 日本原装进口

Welcome To  JAPAN STORAGE BATTERYCO.,LTD.

JAPAN STORAGE BATTERY CO.,LTD.  is anAmerican subsidiary of GS Yuasa Corporation of Japan, the worldleader in motorcycle and standby storage batteries, which servesthe power sports, telecommunications, UPS, and the emergencylighting markets. JAPAN STORAGE BATTERY CO.,LTD. recently enteredthe renewable energy photovoltaic and storage market in NorthAmerica.    GS Battery’s headquarters’ in Roswell,Georgia, is the home of the first commercial solar installationwith batteries in the state of Georgia.

GS Yuasa Corporation’s businesses include themanufacture and supply of batteries, power supply systems, lightingequipment, specialty and other electrical equipment.   Inorder to allow us to offer products and services that best meet theneeds of our customers around the world, we are continually makingmodifications and improvements to our R&D, manufacturing, anddistribution systems, ensuring that they have a globalfocus.

As technological innovation accelerates in theenergy and environmental fields, new values are required in thestorage battery industry. These challenges serve to motivate us andwe continually advance with new products and new technologies intothe changing world before us.    Our corporateslogan, “Next to you”, is where we seek to be as we work towardsmeeting the needs of the changing world.

We give  to making your life richer, toturning your dreams into reality, and to help build a common futurefor everyone.

●ご注意
YTX4L-BSとYT4L-BSでは、サイズ・容量が同じですが、バッテリーの性能が異なっており、YTX4L-BSの方が高性能タイプで始動性能に優れています。
新車搭載がYTX4L-BSの車両にYT4L-BSを搭載されますと、早期エンジン始動不能やバッテリーの短寿命の原因となりますので、YTX4L-BSをご使用されますようお願い致します。

使用UPS时的开机和关机顺序
　　
　　正确的开机关机顺序应该是先打开UPS给它供电，再打开各个负载，这样可以避免启动时瞬间的电流冲击给UPS造成的损害，在关机时的顺序正好应该先关闭各个负载后关闭UPS。在市电中断由UPS供电时，应该尽快保存好自己的数据和资料关闭电脑，否则使用UPS电源进行工作可能会使UPS过量放电，从而缩短UPS的使用寿命。
　
　　在使用UPS的时候还要计算负载的大小，要避免负载的过大或者过小，过大的负载会使UPS长期工作在超负荷状态从而缩短UPS的使用寿命;如果负载过小，UPS的工作电路长期工作在不正常状态，这对于UPS也是有一定危害的。
　　
　　合理的负载应该控制在50%到80%之间。实践证明，UPS输出负载控制在60%左右为佳，可靠性好。在UPS出现过载或逆变器故障时会转到旁路模式运行，此时UPS不具备后备功能，负载所用的电源是通过电力系统直接供应的。